it 3900e Owner's Manual page 23

Innovative Photonics
The following window appears. Click "Assign".
Once complete, the following window appears and you are done.
You have now successfully changed your IP address of the Ethernet enabled device. Make note of
the IP address of this device for future reference.
You can run a quick test of the lightsource using Microsoft® HyperTerminal.

Open a HyperTerminal session and go to File/Properties.

In the "Host Address" line, type in the IP address that you just assigned

Set the "Port Number" to 10001

Click: "OK".
Revision 2 09/01/16
Illumination
Technologies, Inc.
Illumination Technologies, Inc.
102 Route 5 West, Building 2, Elbridge, NY 13060 USA
www.illuminationtech.com
28
Owner's Manual
Page 23 of