Table of Contents
Advertisement
Innovative Photonics
Once the installer launches, it will search the entire network and identify every lightsource attached.
You should see the following screen:
Expand the "Xport" folder on the left side to see the current IP address of the lightsource:
To assign a new IP address, you must first find out your network IP addresses and the subnet mask
information using the following procedures:
Open C:/Command Prompt by going thru the Start Menu/Programs/ and looking under Accessories.
Revision 2 09/01/16
Illumination
Technologies, Inc.
Illumination Technologies, Inc.
102 Route 5 West, Building 2, Elbridge, NY 13060 USA
www.illuminationtech.com
28
Owner's Manual
Page 17 of
Advertisement
Table of Contents
