Table of Contents
Advertisement
Innovative Photonics
Go to "Call" and click on "Call" in the menu
You are now ready to control the lightsource using HyperTerminal. Make sure you set the program to "Echo
Characters."
To begin type the following commands (followed by a "" which is a carriage return) to test the unit's
Ethernet communications interface and functionality:
HEL? (Opens communication with the device)
Response is Ver X.X (where X.X is the firmware revision number)
SSR0=1(Enables the LED lamp)
INT0=4000(Changes intensity to full scale setting)
The LED should now be at full intensity
INT0=1000(Changes intensity to 25% of full scale output)
The LED should now be at 25% full intensity
SSR0=0(Disables the LED lamp)
The LED should shut off completely
SSR0? (Queries the Solid State Relay Status)
The response should be "0" since the SSR is OFF
SSR0=1(Enables the LED lamp again)
The LED should now return to 25% full intensity (the unit will always return to
the last INT value stored when the SSR is activated)
You have now verified the Ethernet interface and the LED driver electronics.
Revision 2 09/01/16
Illumination
Technologies, Inc.
Illumination Technologies, Inc.
102 Route 5 West, Building 2, Elbridge, NY 13060 USA
www.illuminationtech.com
28
Owner's Manual
Page 24 of
Advertisement
Table of Contents
