Table of Contents
Advertisement
Innovative Photonics
USB Option
The USB module used in this controller is configured to work without any additional drivers for
windows computers up to and including Windows XP. If you are running this version on a
computer with a later release than this, you will need to download and install an additional driver
for the module. It can be found at the following website:
http://www.ftdichip.com/Drivers/VCP.htm
At this website, you will see options for downloading drivers based upon the operation system that
you are using. Click the link for the operating system, where it is shown in the comments as
"Available as a setup executable":
This will download a setup executable file that will give your computer system the required drivers
for recognizing the USB port as a new COM port in your computer system. You should save this
file to a directory that you can easily access and remember in case you need to get to it in the
future. Once this file download completes, open the directory in which that file resides, and
double-click to execute it. You may get a warning about the security of the program due to the
publisher not being shown. Click "Yes" as this file will not hurt your computer.
You now have the drivers for the USB module.
You now have remote communication access to the controller for the motorized controller. You
only need to do this one time for each computer that has a controller connected to it.
Revision 2 09/01/16
Illumination
Technologies, Inc.
Illumination Technologies, Inc.
102 Route 5 West, Building 2, Elbridge, NY 13060 USA
www.illuminationtech.com
28
Owner's Manual
COMMUNICATIONS
Page 11 of
Advertisement
Table of Contents
