it 3900e Owner's Manual page 21

Innovative Photonics
In the below the toolbar below the menu bar, click on the "Assign IP" button and the following window
appears:
If you know the address you want to change the module to, keep the "Assign a specific IP Address"
checked (RECOMMENDED). However, before you do this you should verify that the address is not used
by any other device on the network.
To verify that this is an available address, return to the C:/ Command prompt and type "ping
XXX.XXX.XXX.XXX" where "XXX.XXX.XXX.XXX" is the IP address you wish to assign. If a
device responds, do not use that address. If the ping returns a 'timeout' then this address is available.
If the address is available, then click Next and this will open the following window:
Revision 2 09/01/16
Illumination
Technologies, Inc.
Illumination Technologies, Inc.
102 Route 5 West, Building 2, Elbridge, NY 13060 USA
www.illuminationtech.com
28
Owner's Manual
Page 21 of