Lubrication; Lubrication Points - Chassis & Pto Shaft - Goldacres Prairie Compact 2000L MY19 Operator's Manual

Lubrication

Goldacres recommend that a quality multi purpose
grease should be used when lubricating your
equipment.
A SAE 30W40 engine oil should be used in the
diaphragm pump.
Lubrication Points - Chassis & PTO Shaft
GREASE
GREASE
LOCATION
PTO Shaft universal joints
Wheel bearings
Hitch
PTO telescopic shaft
Paralift arm rose ends
Boom lift cylinders
Jack
Induction hopper pivots
NOTE: The drawing above does not show hydraulic cylinders. Each hydraulic cylinder has a grease nipple
located at each end. These points should be greased on a 50 hourly basis.
42 - Chapter 10 - Lubrication & Maintenance
GREASE
The pictures below outline key lubrication points. All
hydraulic cylinders (excluding wing tilt cylinder) have
grease points on the clevis ends.
GREASE
GREASE
GREASE INTERVAL
8 hourly
25 hourly
50 hourly
50 hourly
50 hourly
50 hourly
3 monthly
3 monthly
Prairie Compact 2000L Operator's Manual MY19 - REV 1
GREASE
GREASE
GREASE
GREASE
GREASE