Troubleshooting - Tormach PATHPILOT OPERATOR CONSOLE Installation Manual

TECHNICAL DOCUMENT

2.6 TROUBLESHOOTING

Problem
The touch screen does not respond to touch inputs on all or part of the screen's surface.
Cause
The sensitivity setting for the touch controller is too low.
Solutions
You Might
Probability
Need To...
Adjust High
touchscreen
sensitivity.
©Tormach® 2020
Specifications subject to change without notice.
How-To Steps
1. Verify that you have PathPilot v2.4.4 or higher
installed on your console.
2. From the PathPilot interface, in the MDI Line
DRO field, type
ADMIN TOUCHSCREEN SENSITIVITY 1000
and press Enter. You can use a value between 1
and 2047, but 1000 is generally sufficient for
most shop spaces.
The touchscreen used in the operator console is a resistive
type, to prevent accidental triggering from drops of coolant
on the screen. The resistive touchscreen may need its
sensitivity adjusted when used in a shop space with very high
or low humidity.
Page 9
TD10715: Installation Guide: PathPilot Operator Console for 770 (0420A)
Need More?
tormach.com