Table of Contents
Advertisement
100786 - 3500 PSI PRESSURE WAShER
Do not run the pressure washer without water supply
connected and turned on, as this may damage the high
pressure seals and decrease pump life. Completely unwind the
hose from its reel or coil and make sure the hose is not being
restricted by tires, rocks, or any other objects that may lessen
or prevent water flow to the pressure washer.
Install the Vented Oil Cap
Before using the pressure washer:
1. Unscrew the shipping plug. A 17mm or 11/16" wrench
(not included) may be used.
2. Remove the vented oil plug from the plastic bag.
3. Screw the vented oil plug into the pump by hand.
Do not overtighten.
NOTICE
Add Engine Oil
DO NOT attempt to crank or start the engine before it has been
properly filled with the recommended type and amount of oil.
Damage to the engine as a result of failing to follow these
instructions will void your warranty.
The engine rotor has a sealed, pre-lubricated ball bearing that
requires no additional lubrication for the life of the bearing.
The recommended oil type for typical use is 10W-30
automotive oil.
If running engine in extreme temperatures, refer to the
following chart for recommended oil type.
5W-30
°F
-20
0
20
°C
-28.9
-17.8
-6.7
1. Place the pressure washer on a flat, level surface.
2. Remove oil fill cap/dipstick to add oil.
3. Using a funnel, add up to 20.3 fl. oz. (600 ml) of oil (included)
and replace oil fill cap/dipstick. DO NOT OVERFILL.
4. Check engine oil level at every use and add as needed.
15
CAUTION
NOTICE
NOTICE
Recommended Engine Oil Type
10W-30
10W-40
5W-30 Synthetic
40
60
80
100
4.4
15.6
26.7
37.8
Ambient temperature
ASSEMbLY
120
48.9
Advertisement
Table of Contents
