Table of Contents
Advertisement
ASSEMbly
Your pressure washer requires some assembly . This unit
ships from our factory without oil . It must be properly
serviced with fuel and oil before operation .
If you have any questions regarding the assembly of your
pressure washer, call our help line at 1-877-338-0999 .
Please have your serial number and model number available .
Remove the Pressure Washer from the
Shipping Carton
1 . Set the shipping carton on a solid, flat surface .
2 . Remove everything from the carton except the
pressure washer .
3 . Carefully cut each corner of the box from top to bottom .
Install Handle to bottom frame
1 . Line up the handle with the bottom frame .
2 . Make sure the handle holes are lined up with the
bottom frame spring button . (A)
3 . Slide the handle downward on the bottom frame, until
the spring buttons have popped through the holes on
the handle frame . A "click" may sound . (B)
4 . Gently pull up on the handle to make sure that two
frames have made a solid connection and that the
handle can not be pulled off without pressing on the
spring buttons to release it .
A
7
REV 76520-20120824
b
Add Engine Oil
CAUTION
DO NOT attempt to crank or start the engine before
it has been properly filled with the recommended
type and amount of oil . Damage to the pressure
washer as a result of failure to follow these
instructions will void your warranty .
NOTE
The recommended oil type is 10W-30 automotive oil .
1 . Place the pressure washer on a flat, level surface .
2 . Remove oil fill cap/dipstick to add oil .
3 . Add up to 0 .63 qt . (0 .6 L) of oil and replace oil fill
cap/dipstick .
4 . Check engine oil level daily and add as needed .
CAUTION
The engine is equipped with a low oil shut-off and
will stop when the oil level in the crankcase falls
below the threshold level .
NOTE
Check oil often during the break-in period . Refer to
the Maintenance section for recommended service
intervals .
76520
ENGLISH
Hide quick links:
Advertisement
Table of Contents
