Assembly; Remove The Pressure Washer From The Shipping Carton; Install Handle To Bottom Frame; Wheel Assembly - Champion Power Equipment 76525 Owner's Manual & Operating Instructions

ASSEMBly

Your pressure washer requires some assembly. This unit
ships from our factory without oil. It must be properly
serviced with fuel and oil before operation.
If you have any questions regarding the assembly of your
pressure washer, call our help line at 1-877-338-0999.
Please have your serial number and model number available.
Remove the Pressure Washer from the
Shipping Carton
1. Set the shipping carton on a solid, flat surface.
2. Remove everything from the carton except the
pressure washer.
29
3. Carefully cut each corner of the box from top to bottom.
30

Install Handle to Bottom frame

23
1. Line up the handle with the bottom frame.
2. Make sure the handle holes are lined up with the
bottom frame spring button. (A)
3. Slide the handle downward on the bottom frame, until
the spring buttons have popped through the holes on
the handle frame. A "click" may sound. (B)
4. Gently pull up on the handle to make sure that two
frames have made a solid connection and that the
handle can not be pulled off without pressing on the
spring buttons to release it.
A
7
REV 76525-20140126
B

Wheel Assembly

1. Slide Wheel Bolt (#28) through the Wheel (#27) from
the outside.
2. Slide Wheel Washer (#26) on the Wheel Bolt (#28).
3. Insert the Bolt through the wheel bracket on the
frame.
4. Secure the Nut (#25).
5. Repeat steps 1-4 for second wheel.

Support foot Assembly

1. Align the Support Foot (#30) with the holes in the
front of the frame.
2. Insert an M8x65 screw (#29) through each hole from
the top.
3. Secure each screw with an M8 nut (#23) from below.
29
30
23
76525
ENGLISH
25
26
27
28