Champion Power Equipment 100786 Operator's Manual page 18

100786 - 3500 PSI PRESSURE WAShER
3. Move the choke lever to the "CHOKE" position.
4. Pull the starter cord slowly until resistance is felt and then
pull rapidly. SEE NOTE.
5. As engine warms up, move the choke lever to "RUN" and
adjust the throttle as needed.

Keep choke lever in "CHOKE" position for 2 pulls of the recoil
starter. After second pull, move choke lever to the "RUN"
position for up to the next 3 pulls of the recoil starter. To much
choke leads to spark plug fouling/engine flooding due to the
lack of incoming air. This will cause the engine not to start.
NOTICE
If the engine does not start after 2 pulls, relieve pump pressure
by pulling the trigger on the trigger gun.
If the engine starts but does not run make certain that the
pressure washer is on a flat, level surface. The engine is
equipped with a low oil sensor that will prevent the engine
from running when the oil level falls below a critical threshold.
18
OPERATION
NOTICE

NOTICE
