Huawei SmartLi-80Ah User Manual page 69

SmartLi-80Ah
User Manual
Table 4-10 System Settings
Item
Battery cabinet
quantity
EPO enable
Battery cabinet
copper bar over
temp. enable
Fire control enable
Table 4-11 Settings Wizard
Item
Language
Time
Network Param.
System Param.
Table 4-12 User Settings
Item
Issue 02 (2020-05-17)
 After you restart the device, IP address allocation changes back to Manual. The IP address is set to
the IP address set previously.
 Ensure that the UPS IP address is unique on the network segment. Otherwise, the WebUI display
function may not function properly.
Description
Specifies the number of battery
cabinets connected in parallel.
EPO (emergency power-off) is
performed only when this
parameter is enabled and the
EPO switch is triggered.
When EPO detection is changed
from Disable to Enable, check
that the EPO cable is connected
correctly.
If this parameter is set to Enable,
an alarm is reported when the
copper bar is overheated.
If this parameter is set to Enable,
an alarm is reported after the fire
extinguishing action is triggered.
Parameter
English, Chinese
Date format, YYYY-MM-DD, Time zone,
City, Time
IP Address allocation, IP address, Subnet
mask, Gateway
Battery cabinet quantity, EPO enable,
Battery cabinet copper bar over temp.
enable, Fire control enable
Description
Copyright © Huawei Technologies Co., Ltd.
Default
Value
1
Disable
Enable
Enable
Default Value
4 User Interface
Value Range
1–8
Disable, Enable
Disable, Enable
Disable, Enable
Description
Set based on site
requirements.
Set based on site
requirements.
Set based on site
requirements.
Set based on site
requirements.
Value Range
62