Electromagnetic Compatibility - Kane 455 Manual

11. ELECTROMAGNETIC COMPATIBILITY

European Council Directive 89/336/EEC requires electronic equipment not to generate
electromagnetic disturbances exceeding defined levels and have adequate immunity
levels for normal operation. Specific standards applicable to this analyser are stated
below.
As there are electrical products in use pre-dating this Directive, they may emit excess
electromagnetic radiation levels and, occasionally, it may be appropriate to check the
analyser before use by:
Use the normal start up sequence in the location where the analyser will be
used.
Switch on all localized electrical equipment capable of causing interference.
Check all readings are as expected. A level of disturbance is acceptable.
If not acceptable, adjust the analyser's position to minimize interference or
switch off, if possible, the offending equipment during your test.
At the time of writing this manual (December 2009) Kane International Ltd are not
aware of any field based situation where such interference has occurred and this
advice is only given to satisfy the requirements of the Directive.
Please Note:
Batteries used in this instrument should be disposed of in accordance with current
legislation and local guidelines.
At the end of the product's life it should be re-cycled in accordance with current
legislation and local guidelines.
For latest prices and delivery to your door visit MyTub Ltd - www.mytub.co.uk - info@mytub.co.uk For latest prices and delivery to your door visit MyTub Ltd - www.mytub.co.uk - info@mytub.co.uk
This product has been tested for compliance
with the following generic standards:
EN 61000-6-3 : 2001
EN 61000-6-1 : 2001
and is certified to be compliant
Specification EC/EMC/KI/K455 details the
specific test configuration, performance and
conditions of use.
KANE455 manual Page 32