Electromagnetic Compatibility - Kane 3500 Manual

7. ELECTROMAGNETIC COMPATIBILITY

European Council Directive 89/336/EEC requires electronic equipment not to generate
electromagnetic disturbances exceeding defined levels and have adequate immunity levels
for normal operation. Specific standards applicable to this meter are stated below.
As there are electrical products in use pre-dating this Directive, they may emit excess
electromagnetic radiation levels and, occasionally, it may be appropriate to check the meter
before use by:
Use the normal start up sequence in the location where the meter will be used.
Switch on all localized electrical equipment capable of causing interference.
Check all readings are as expected. A level of disturbance is acceptable.
If not acceptable, adjust the meter's position to minimize interference or switch off, if
possible, the offending equipment during your test.
At the time of writing this manual (June 2014) Kane International Ltd are not aware of any
field based situation where such interference has occurred and this advice is only given to
satisfy the requirements of the Directive.
Please Note:
Batteries used in this instrument should be disposed of in accordance with current legislation
and local guidelines.
At the end of its life the meter should be sent to the appropriate recycling centre in
accordance with current legislation and local guidelines
This product has been tested for compliance
with the following generic standards:
EN 61000-6-3 :2011
EN 61000-6-1 :2007
and is certified to be compliant
Specification EC/EMC/KI/KANE3500 details
the specific test configuration, performance
and conditions of use.
KANE3500 Manual Page 13