PowerCube 5000
User Manual (SmartLi 100Ah)
10.1 How Do I Install an Expansion Sleeve
Step 1 Drill a hole into the concrete floor using a hammer drill. The hole depth should range from 52
mm to 60 mm.
Step 2 Slightly tighten the expansion bolt and vertically insert it into the hole. Knock the expansion
bolt using a rubber mallet until the expansion sleeve is fully inserted into the hole.
Step 3 Partially tighten the expansion bolt.
Step 4 Remove the expansion bolt, spring washer, and flat washer.
Figure 10-1 Drilling a hole and installing an expansion sleeve
(1) M12 bolt
(4) Expansion sleeve
----End
Issue 02 (2020-03-17)
(2) Spring washer
(5) Expansion nut
Copyright © Huawei Technologies Co., Ltd.
10
FAQ
(3) Flat washer
(6) Concrete floor
10 FAQ
144