Hyundai HRP-S09WH Service Manual page 21

Refrigerant r32
Table of Contents

Advertisement

Function and Control
Function and Control
Low temperature heating function setting
● In heating mode, pressing "MODE" and "
● "
" would be showed on the remote controller after entered into the low temperature heating funtion.
● When switching from one mode to another mode, low temperature heating function was canceled. Turn off and then turn on air
conditioner that will remain the low temperature heating function. After powered on, the low temperature heating mode was
default to off status.
● In the low temperature heating function, "Sleep" and "Low temperature heating" function cannot start at the same time. When
low temperature heating function has already started, meanwhile you press the "SLEEP" button, the air conditioner will exit low
temperature heating mode and enter the sleep mode. Vice versa.
Note:
1. In the low temperature heating function, the fan speed was default to Auto and non-ajusatable.
2. In the low temperature heating function, Turbo function can't be set. If enter the low temperature heating function, the turbo and
quiet function that started before will be canceled. As well as when exit the low temperature heating function, it will resume .
3. When exit from the low temperature heating function, the speed and temperature will turn into the original condition before it
started.
4. You can set up other function.
Installation batteries
1. Press the back side of remote controller marked with "
fi g, and then push out the cover of battery box along the arrow direction.
2. Installation two 7# (AAA 1.5V) dry batteries, and make sure the position of "+"
polar and "-" polar are correct.
3. Reinstall the cover of battery box.
Operation guide
1. After connecting the power, press "
2. Press "MODE" button to select your required mode: Auto, Cool, Dry, Fan, Heat.
3. Press "
" or "
" button to set your required temperature. (Temperature can't be adjusted under auto mode).
4. Press "FAN" button to set your required fan speed: auto , quiet , fan1, fan2 , fan3 , fan4 , fan5 , stepless speed.
5. Press "SWING" button to turn on or turn off the swing function.
NOTE:
● During operation, point the remote control signal sender at the receiving window on indoor unit.
● The distance between signal sender and receiving window should be no more than 8m, and there should be no obstacles between them.
● Signal may be interfered easily in the room where there is fl uorescent lamp or wireless telephone; remote controller should be close to indoor
unit during operation.
● Replace new batteries of the same model when replacement is required.
● When you don't use remote controller for a long time, please take out the batteries.
● If the display on remote controller is fuzzy or there's no display, please replace batteries.
18
" button at the same time will enter/exit the low temperature heating function.
", as shown in the
" button on remote controller to turn on the air conditioner.

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Hrp-s12whHrp-s18whHrp-s24wh

Table of Contents