Removal Procedure
Removal Procedure
82
Procedure
Electric box
Motor press plate
Note
7. Remove electric box
A: Disconnect the indoor tube temperature
sensor.
B: Remove the screws at the joint of the
earthing wire and evaporator.
C: Loosen the clasp at the joint of the electric
box.
8. Remove evaporator
A: Remove the screws at the joint of the
evaporator and rear case.
B: Adjust slightly the pipe on the evaporator to
separate the pipe with the evaporator.
C: Remove the evaporator to separate the
evaporator with rear case assy.
9. Remove motor press plate
Remove the screw of the motor press plateand
then remove the press plate.