Add/Edit Internet Connection - ZyXEL Communications LTE Series User Manual

Figure 58 Network Setting > Broadband
The following table describes the labels in this screen.
Table 19 Network Setting > Broadband
LABEL
#
Name
Type
Mode
Encapsulation
802.1p
802.1q
IGMP Proxy
NAT
Default
Gateway
IPv6
MLD Proxy
Modify

6.2.1 Add/Edit Internet Connection

Click the Edit or Modify icon to open the following screen. Use this screen to configure a WAN
connection.
Chapter 6 Broadband
DESCRIPTION
This is the index number of the entry.
This is the service name of the connection.
This shows whether it is a cellular or Ethernet connection.
This shows the connection is in routing mode.
This is the method of encapsulation used by this connection.
This indicates the 802.1p priority level assigned to traffic sent through this connection. This
displays N/A when there is no priority level assigned.
This indicates the VLAN ID number assigned to traffic sent through this connection. This displays
N/A when there is no VLAN ID number assigned.
This shows whether the Zyxel Device act as an IGMP proxy on this connection.
This shows whether NAT is activated or not for this connection.
This shows whether the Zyxel Device use the WAN interface of this connection as the system
default gateway.
This shows whether IPv6 is activated or not for this connection. IPv6 is not available when the
connection uses the bridging service.
This shows whether Multicast Listener Discovery (MLD) is activated or not for this connection. MLD
is not available when the connection uses the bridging service.
Click the Edit or Modify icon to configure the WAN connection.
Click the Delete icon to remove the WAN connection.
LTE Series User's Guide
85