Avaya S8100 Series Manual page 1161

Task
6. Verify that the media
gateway has registered
with the primary
controller.
See the "To verify
changes" subsection
under "Administering the
Media Gateway" in
Chapter 9.
7. If IA770 is installed, get
IA770 data and stop
IA770.
See "Getting IA770
(AUDIX) data and
stopping IA770 (if IA770 is
being used)" in Chapter
12.
8. Record configuration
information.
See "Recording
configuration information"
in Chapter 11.
9. Restore default server
configuration settings
10. Set time, date, and time
zone.
See "Verifying Time, Date,
and Timezone" in Chapter
12.
On the LSP's primary controller
Open a SAT session and enter list
●
media-gateway. Verify that the Registered field
(Reg?) is set to y.
Place a test call.
●
On the ICC/LSP
If you have not already done so, in the Record
Configuration Information task, record all of the
configuration information, regardless of the fact that you
are not upgrading Communication Manager.
You will re-enter some of this information after the
conversion.
On the Maintenance Web Interface, click Restore
Defaults under Server Configuration.
The time of the LSP must be set to the same time zone as
its primary controller, even if the LSP is physically located
in a different time zone.
Steps/Comments
Issue 2.1 June 2006
Introduction
3 of 5
1161