Avaya S8100 Series Manual page 1090

Converting some or all CSS port networks to IP-PNC
IPSI slot locations (continued)
Carrier or Gateway
MCC1 EPN containing three
PNs
MCC1 EPN containing four PNs
MCC1 EPN containing five PNs
Installing the new circuit packs
!
Important:
In some cases, you might need to remove an existing circuit pack from a slot
Important:
before you install the new circuit pack. Remove these existing circuit packs last,
after you install, cable, and administer all the new circuit packs that go into empty
slots. To remove existing circuit packs, follow the procedures in
duplication, if necessary
administration
Tip:
The TN2312BP, the TN2602AP, and the TN799D circuit packs all support
Tip:
hot-plug-in. That is, you can be insert them into a live system without disrupting
call processing.
1090 Upgrading, Migrating, and Converting Media Servers and Gateways
Primary
Tone Clock slot
●
(A00)
B02
●
D02 (single control)
●
E02 (duplicated
●
control)
Tone Clock slot
●
(A00)
B02
●
C02
●
D02 (single control)
●
E02 (duplicated
●
control)
Tone Clock slot
●
(A00)
B02
●
C02
●
D02
●
E02
●
on page 1098 and
on page 1099.
Slot Number
Secondary, if duplicated
control, for S8700 series
only
Control duplication not
supported with 3 PNs.
D01 (duplicated control)
Control duplication not
supported with 4 PNs
D01 (duplicated control)
Control duplication not
supported with 5 PNs
Disabling PNC
Removing fiber-related
2 of 2