Removal And Replacement Procedures; Bottom Cover - HP ENVY x360 15 Maintenance And Service Manual

5

Removal and replacement procedures

IMPORTANT:
Accessing these parts can damage the computer or void the warranty.
NOTE: HP continually improves and changes product parts. For complete and current information about
supported parts for the computer, go to http://partsurfer.hp.com, select the country or region, and then follow
the on-screen instructions.
Component replacement procedures
There are as many as 57 screws that must be removed, replaced, or loosened when servicing the computer.
Make special note of each screw size and location during removal and replacement.

Bottom cover

Table 5-1 Bottom cover spare part information
Description
Bottom cover
Remove the bottom cover:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet, and then
unplugging the AC adapter from the computer.
4. Close the computer and position it upside down.
5. Remove the front (1) and rear rubber foot strips.
The rubber foot strips are available using spare part number L93198-001.
Components described in this chapter should only be accessed by an authorized service provider.
Spare part number
L94070-001
Component replacement procedures 25