Solid-State Drive - HP ENVY x360 15 Maintenance And Service Manual

Reverse this procedure to install the front speakers.

Solid-state drive

Table 5-3 Solid-state drive spare part information
Description
1 TB, M.2 2280, PCIe, NVMe 3×4, SS solid-state drive with TLC
512 GB, M.2 2280, PCIe 3×4, SS solid-state drive with TLC
512 GB, M.2 2280, PCIe, NVMe value solid-state drive
256 GB, M.2 2280, PCIe 3×4, SS solid-state drive with TLC
256 GB, M.2 2280, PCIe, NVMe value solid-state drive
Before removing the solid-state drive, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet, and then
unplugging the AC adapter from the computer.
4. Remove the bottom cover (see
5. Disconnect the battery cable from the system board (see
Remove the solid-state drive:
1. Detach the tape (1) that secures the solid-state drive shield to the memory module shield.
2. Remove the Phillips M2.0×4.1 screw (2) that secures the solid-state drive shield to the keyboard/top cover.
3. Remove the solid-state drive shield (3).
4. Remove the Phillips M2.0×3.5 screw (1) that secures the solid-state drive to the keyboard/top cover.
28 Chapter 5 Removal and replacement procedures
Bottom cover on page 25).
Front speakers on page 27).
Spare part number
L85348-005
L85360-005
L85364-005
L85350-005
L85354-005