Table of Contents
Advertisement
www.raisecom.com
7.2 Installation procedures
7.2.1 Device installation
Please fix the chassis on to the rack and insert the device into the slot of the chassis. Please fasten all
screws.
If network management will not be used, please make sure that the DIP switches on the module have
been set according to need before being fixed into the chassis.
7.2.2 Cable connection
Please make sure that the E1 interfaces and the optical interface are well connected.
7.2.3 Device electrifying
Please fix the module properly in the chassis before turning ON the power supply.
After electrifying, the power supply status indicator PWR on the front panel of the device will turn
ON to show that the power supply is working normally.
User Manual
14
Advertisement
Table of Contents
