Englefield Tapware Studio II Slide Shower 22980A-CP Installation Instructions

STUDIO II SLIDE SHOWER
SPARE PARTS LIST
Hand shower Hand shower
(single mode) (multi modes)
1397398
1397397
Hose washer
1239241
Elbow
1358461-CP
Shower hose
1241297
CONTACT AND WARRANTY INFORMATION
NEW ZEALAND AUSTRALIA
KOHLER NZ LTD KOHLER AUSTRALIA
Free Ph: 0800 100 382 Free Ph: 1 800 ENGLEFIELD
Free Fax: 0800 664 488 (1 800 364 533)
www.englefield.co.nz
www.englefield.com
For warranty information, please visit our website
1397399-AN2-A 06/07/2019
INSTALLATION INSTRUCTIONS
Cap
1239238
Clamp bracket
1239242
Mounting bracket kit
1239236
Taper block
1239247
Soap dish
1239246
Page 4
INSTALLATION
INSTRUCTIONS
TAPWARE
ENGLEFIELD 1397399-AN2-A 06/07/2019
STUDIO II
SLIDE SHOWER
BEFORE YOU BEGIN
All information is based on the latest product information available at the time
of publication. Englefield reserves the right to make changes in product charac-
teristics, packaging, or availability at any time without notice.
Please leave this installation instructions guide for the consumer.
It contain important information.
NOTES:
1. Flush the water supply pipes thoroughly to remove debris.
2. An in-line filter must be used with this product.
3. The working pressure of hand shower is between 100 kPa and 500 kPa.
If it exceeds 500 kPa, a pressure limiting valve must be fitted.
4. The operating temperature of hand shower is from 10˚C to 70˚C. NZ
building code G12 requires that maximum hot water temperature at any
sanitary fixture used for personal hygiene shall not exceed either 45˚C or
55˚C. If so, a tempering valve must be installed.
5. This shower is intended for high/mains pressure installations. It may not
be suitable for use with gravity-fed water heaters, low and unequal pres-
sure supplies.
6. All installations should comply with local plumbing codes and the relevant
requirements of AS/NZS 3500 and AS/NZS 6400.
ROUGH-IN DIMENSIONS
Ø 90
G 1/2"B
22980A-CP
22981A-CP
29689A-CP
G 1/2"B
1524
* All measurements shown are in milimetres
ENGLEFIELD