Electromagnetic Compatibility Specifications; Accessories - Aspect BIS VIEW Service Information Manual

SECTION 9
_______________________________________________________________________
9.2

Electromagnetic Compatibility Specifications

The BIS VIEW Monitoring System requires special precautions regarding Electromagnetic
Compatibility (EMC). The BIS VIEW system must be installed and put into service
according to the EMC guidance information provided in this section.
Portable and mobile radio frequency communications equipment can affect the operation of
the BIS VIEW Monitoring System. Refer to the EMC guidance information and Cautions
provided in this manual.

9.2.1 Accessories

The BIS VIEW Monitoring System complies with the requirements of IEC 60601-1-2:2001
when used with the accessories listed in Section 2 of the Operating Manual. In addition, the
BIS VIEW system must be used only with the power cord provided.
When using the Software Upgrade Device to load new versions of software into the BIS
VIEW monitor, no cables or other accessories should be connected to the device. The BIS
VIEW monitor should be connected to the mains through the appropriate power cord, and
the Software Upgrade Device should be plugged into the USB-A connector on the back of
the device.
Using accessories other than those specified may result in increased
electromagnetic emissions or decreased electromagnetic immunity of
the BIS VIEW Monitoring System.
SPECIFICATIONS AND WARRANTY
Caution:
9-5