Performing A Software Update - Aspect BIS VIEW Service Information Manual

SECTION 8

8.11 Performing a Software Update

The BIS VIEW system software may be updated by attaching a removable drive containing
the update to the USB port on the rear of the monitor. The progress of the update displays
on the monitor screen. When the update is complete, the user is asked to reset the system.
The monitor must be connected to A/C power to perform the update.
When software is updated, all monitor configuration settings will be lost.
Additionally, previously recorded data may be lost. Therefore, configuration
settings and previous data should be recorded before the software update is
performed.
Follow these steps to perform the update:
Do not disconnect the BISx during the software update.
1. Before attempting an update, be sure to record your institution's saved settings, as
they may be erased during the update procedure. See the BIS VIEW Operating
Manual Section 3.6.3.5 "Settings: Active and Saved Monitor Settings" for
instructions.
2. Power the monitor down completely by unplugging the power cord and then
pressing the ON/Standby button until the light on the right side of the button goes
out.
3. Re-connect the power cord to AC power, then press the ON/Standby button to
start up the monitor. The light should be green.
4. Insert the USB drive containing the software update into the USB port (Type A) at
the rear of the monitor.
5. Press [MENU] to access the Main Menu.
6. Use the [▲] or [▼] key to highlight [Maintenance], then press [SELECT]. The
Maintenance Menu displays.
7. Press [Software Update]. As soon as the updating device is detected, the message
"Updates Detected" appears on the screen.
8. Press [Continue] to initiate the update. (To skip the update, Press [Cancel]. The
monitor will operate with the current software.) The update begins. Do NOT
remove the USB drive during the updating process.
9. If the message, "Connect BISx to monitor" appears on the screen, a BISx software
update is available. Connect the BISx to continue with the update, or press [Cancel]
to skip the update.
10. When the update is complete, the message "Update Complete" appears. Press
[RESET]. The monitor and BISx will reset, and you can then resume normal
operation.
SERVICING THE BIS VIEW MONITORING SYSTEM
Notes:
Caution:
8-14