AEG Protect D Series User Manual page 38

38
Auto reboot
The UPS automatically restarts if utility returns after the output was shut
off due to exhausted batteries, a shutdown input signal, or automatic
shutdown command.
You can set the load segment for the amount of time to delay the restart
once utility returns, using the "Automatic Start Delay" setting. You can also
configure UPS restart to depend on the battery charge level, using the
"Battery Charge Capability % to Restart" setting.
Description
Auto bypass
Clear Event Log
LCD Contrast
hours, UPS will make bat low
alarm and then shutdown itself 30
minutes later even battery
voltage still above the shutdown
value.
Disabled means "No time
limitation" for battery mode
[enabled], [disabled]
Enabled means UPS will auto
restart to normal mode while
utility recover after the UPS has
been shut down for battery low.
Adjustable parameters
[enabled], [disabled]
"enabled" means UPS will have
bypass output when utility power
on.
"disabled" means UPS will not
have bypass output when power
on but could get bypass output
when UPS is fault or overload.
The number after "Total events"
shows how many events are
currently stored in the log.
Press the " " button for one
second to reset the event count
to zero and clear the log.
[-5], [-4], ...[-1], [0], [+1], ...[+4],
[+5]
The LCD Contrast is adjustable
and the valid range is from -5 to
+5.
enabled
Presetting
enabled
—
0