27
EN
5.5 UPS turn ON
Insert the plug of the power cord into the correctly fused power outlet of
your sub-distribution system. The UPS will be immediately supplied with
power from the public power network. It will start up with an initialization
phase, indicated by the AEG logo, which appears on the screen for 5
seconds. After that, you will see the following message:
Now confirm the highlighted "UPS On" command by pressing "
".
Hold the key pressed for approx. 1 second. The UPS will synchronize and
switch into normal operating mode after just a few seconds. The display
will switch to the UPS status display.
If there are no keys pressed for 5 minutes, the display will automatically
switch back to the UPS status display.
5.6 UPS Turn off
If the UPS is in operation, it is possible to access the command above by
pressing "
" when in the basic UPS status screen.
Once you have confirmed the command again, the UPS will switch off or
switch to bypass (depending on the setting selected).