Advertisement
8. Insert 8 sets of: Flat Washer (H), Spring Washer (G), and Allen Bolt (F) through the pre-drilled holes on the
Supports and into the pre-inserted nuts, as seen in the illustration below.
9. Tighten with Allen Key (E).
10. If needed, adjust the levelers underneath the bottom legs (up or down) to keep the whole set level, as seen
below.
11. NOTE: Installation of the Anti Tip Kit is REQUIRED. Please follow the separate instructions to secure the
Desk to the Wall, by using the tipping-restraint kit included.
Care Instructions:
Dust often using a clean, soft, dry, and lint-free cloth.
Blot spills immediately and wipe with a clean, damp cloth.
We do not recommend the use of chemical cleansers, abrasives, or furniture polish on our lacquered finish.
Hardware may loosen over time. Periodically check to make sure all connections are tight.
Re-tighten if necessary.
Date: 2014-July-14
Rev:
Thank you for your purchase
Stores | catalog | www.potterybarnkids.com
USA 1.800.290.8181
F
8x
G
8x
H
8x
Page 4 of 4
Advertisement
