Advertisement
Hardware Included:
(E) – B all Tip Allen Key 4x95x30mm
(x1)
(H) – Flat Washer 1/4x12x1.5mm (x8)
Assembly Instruction Steps:
1. Place the Middle Mirror (A) on the carpet or the foam from inside the shipping box.
2. Attach the Left Mirror (B) to the Middle Mirror (A) by aligning the pre-drilled holes on the Left Mirror's hinge,
with the pre-inserted nuts on the side of the Middle Mirror, as seen in the illustration below.
3. Insert 6 Machined Screws (I) through the pre-drilled holes on the hinge and into the pre-inserted nuts, as
shown below.
4. Slowly tighten the Machined Screws (I) with a Philips Head Screwdriver. (Not included)
5. Repeat steps #2 to #4 to assemble the Right Mirror (C) to the Middle Mirror (A), as shown in the illustration
below.
I
12x
6. Carefully place the Blythe Vanity Topper on the back rear of the Blythe Desk (SOLD SEPARATELY). Make
sure the topper doesn't scratch or damage the surface of the Desk.
7. Attach the 2 Supports (D) to the back of Middle Mirror (A) and the Blythe Desk by aligning the pre-drilled
holes on the Supports (D), with the pre-inserted nuts on the back of the Middle Mirror and Blythe Desk, as
seen in the illustration below.
Date: 2014-July-14
Rev:
(F) – Allen Bolt 1/4"x38x13mm (x8)
(I) – Machined Screw 5 /32x13mm
(x12)
(G) – Spring Washer
1/4x10x1.5mm (x8)
Page 3 of 4
Advertisement
