Electrical Connection; Before Inserting The Plug Into The Electrical Socket; Advice Regarding The First Wash Cycle; Positioning The Appliance - Kogan 9 Series User Manual

Electrical connection

Before inserting the plug into the electrical socket, make sure that:
•
The socket is earthed and complies with current regulations.
•
The socket can withstand the maximum load of the appliance, which is indicated
on the data plate located on the inside of the door
•
The power supply voltage falls within the values indicated on the data plate on the
inside of the door.
•
The socket is compatible with the plug of the appliance. If this is not the case,
contact Kogan.com; do not use extension cables or multiple sockets.
•
Once the appliance has been installed, the power supply cable and the electrical
socket should be easily accessible.
•
The cable should not be bent or compressed. If the power supply cable is
damaged; it must be replaced by Kogan.com or its service agent to prevent all
potential hazards.
•
Kogan.com shall not be held responsible for any incidents that occur if these
regulations are not observed.

Advice regarding the first wash cycle

•
After the appliance has been installed, immediately before running the first wash
cycle, fill the rinse aid dispenser.

Positioning the appliance

•
Position the appliance in the desired location. The back should rest against the wall
behind it, and the sides along with the adjacent cabinets or wall. The water supply
and drain hoses that can be positioned to the right or the left to facilitate proper
installation.
Levelling the appliance
•
Once the appliance is positioned, adjust the feet (screwing them in or out) to adjust
the height of the dishwasher, making it level. In any case, the appliance should not
be inclined more than 2°.
Note:
The maximum adjustment height of the feet is 20 mm.