Turning On The Appliance; Change The Program; The 6 Program Lights Show The Status Of The Dishwasher - Kogan 9 Series User Manual

Turning on the appliance

To start a wash cycle, draw out the lower and upper basket, load the dishes and:
1. Push them back. It is recommended to load the lower basket first, then the upper
one (see the section entitled "Loading the dishwasher baskets" above). Pour in the
detergent.
2. Insert the plug into the socket. The power supply is 220V-240V AC 50Hz; the
specification of the socket is 12 A 250 VAC/50 Hz.
Make sure that the water supply is turned on to full pressure. Close the door, press
the "Power" button and press the "program" button to select a desired wash cycle.
(See the section entitled "Wash Cycle Table" above).
A click should be heard when the door is closed correctly. When the washing is over, the
appliance can be shut off by pressing the "Power" button.

Change the program

• Premise: A cycle that is underway can only be modified if it has only been running
for a short time. Otherwise, the detergent may have already been released and the
appliance may have already drained the wash water. If this is the case, the
detergent dispenser must be refilled (see the section entitled "Fill in the
Detergent").
•
Press the "Power" button and turn on it again. Press the "program" button to
choose the expected cycle setting (see the section entitled "Starting a wash
cycle").
Note:
If the doors opened when a washing cycle is underway, the appliance will pause and
emit warning signals, and the display will show the E1 error code. When the door is
closed, the dishwasher will recommence operation after ten seconds.

The 6 program lights show the status of the dishwasher:

a) One of the program lights illuminated: cycle running
b) One of the program lights blinking: cycle paused
Note:
If all the lights begin to flash, this indicates the machine is out of order. Turn
off the main power and water supply before contacting Kogan.com.