Connection Of Drain Hoses - Kogan KAFREEWASHA Instruction Manual / Installation Manual

Connection Of Drain Hoses

LEVELLING THE APPLIANCE
Position the dishwasher on a level and sturdy floor. If the floor is uneven, the front feet of the
appliance may be adjusted, just screw the feet in or out a little until it reaches a horizontal position
(the angle of inclination must not exceed 2 degrees).
Correctly levelled, the appliance will be more stable and much less likely to move or cause
vibrations and noise during operation.
WATER CONNECTION
Connect the water supply hose to a threaded 3/4" cold water connector. During use, the
dishwasher will heat up the water to the required temperature. Make sure the hose is not kinked or
squashed and is fastened tightly in place using appropriate tools if required. If the water pipes are
new or have not been used for an extended period of time, let the water run to make sure it is clear
and free of impurities. This step is necessary to avoid the risk of the water inlet being blocked and
damaging the appliance.
ordinary supply hose
ordinary supply hose
Connection Of Drain Hoses
Insert the drain hose into a drain pipe with a minimum diameter of 4 cm, or let it run
into the sink, making sure to avoid bending or crimping it. The height of drain pipe
must be less than 1000mm. The free end of the hose must not be immersed in water
to avoid the back flow of it.
Please securely fix the drain hose in either position A or position B
Back of dishwasher
Mains Cable
How to drain excess water from hoses
If the sink is 1000 higher from the floor, the excess water in hoses cannot be drained
directly into the sink. It will be necessary to drain excess water from hoses into a bowl
or suitable container that is held outside and lower than the sink.
safety supply hose
safety supply hose
Drain hose
Water Inlet
Drain Pipe
17
A
B
Counter