Warnings - Graco SaniSpray HP 20 Operation - Repair - Parts

Warnings

The following warnings are for the setup, use, grounding, maintenance, and repair of this
equipment. The exclamation point symbol alerts you to a general warning and the hazard
symbols refer to procedure-specific risks. When these symbols appear in the body of this
manual or on warning labels, refer back to these Warnings. Product-specific hazard symbols
and warnings not covered in this section may appear throughout the body of this manual where
applicable.
CHEMICAL HAZARD
Toxic disinfectant or fumes can cause serious injury or death if splashed in the eyes or on
skin, inhaled, or swallowed.
•
Keep away from children.
•
Use only to spray surfaces. Do not spray humans or animals.
•
Use only with appropriate personal protective equipment. See PERSONAL PROTECTIVE
EQUIPMENT, page 8.
•
Follow all directions and requirements on disinfectant label. It is a violation of Federal law
to use an EPA-approved disinfectant in a manner inconsistent with its labeling.
•
Flush with water after each use. Never store disinfectant in equipment.
•
Read Safety Data Sheets (SDSs) to know the specific hazards of the disinfectants you are
using.
•
Store and dispose of disinfectants according to instructions on disinfectant container
labels.
SKIN INJECTION HAZARD
High-pressure spray is able to inject toxins into the body and cause serious bodily injury that
can result in amputation. In the event that injection occurs, get immediate surgical
treatment.
•
Use only to spray surfaces. Do not spray humans or animals.
•
Do not point spray tip at anyone or place any part of your body in front of tip. For example,
do not try to stop leaks with any part of the body.
•
Always use the spray tip guard. Do not spray without spray tip guard in place. Use only
Graco spray tips.
•
Use caution when cleaning and changing spray tips. In the case where the spray tip clogs
while spraying, follow the Pressure Relief Procedure, page 10, for turning off the unit and
relieving the pressure before removing the spray tip to clean.
•
Equipment maintains pressure after power is shut off. Do not leave the equipment
energized or under pressure while unattended. Remove battery and follow the Pressure
Relief Procedure, page 10, when the equipment is unattended or not in use, and before
servicing, cleaning, or removing parts.
•
Check parts for signs of damage. Replace any damaged parts.
•
This system is capable of producing 1000 psi (69 bar, 6.9 MPa). Use Graco replacement
parts or accessories that are rated a minimum of 1000 psi (69 bar, 6.9MPa).
•
Do not carry the sprayer with a finger on the trigger.
•
Verify that all connections are secure before operating the unit.
•
Know how to stop the unit and bleed pressure quickly. Be thoroughly familiar with the
controls.
3A7649A
WARNING
Warnings
7