Starting A New Job - Graco SaniSpray HP 20 Operation - Repair - Parts

Starting a New Job

When spraying flammable or combustible
disinfectants:
•
Move entire sprayer to a well-ventilated
area and away from flammable or
combustible materials, including
disinfectants, when refilling.
•
Keep disinfectant containers covered
between cup refills.
If you are using the sprayer for the very first
time, see Flushing a New Sprayer, page 11.
1. Perform Pressure Relief Procedure,
page 10.
2. Install a FlexLiner into the Cup Support.
3. Fill FlexLiner with disinfectant.
3A7649A
4. Firmly tighten Cup Lid onto the Cup
Support to ensure an airtight seal.
NOTE: Petroleum jelly on the inside of the top
of the Cup Lid will help ensure an airtight seal.
5. Verify Pump Filter is installed and clean.
6. Install the cup assembly onto the sprayer
as follows:
a.
b.
ti23361a
Start Up
Align VacuValve Cap on the Cup
Lid with the Prime Pump/Spray
Knob.
Push cup assembly onto the
sprayer. Twist to lock.
ti29719a
13