Start Up; Starting A New Job - Graco TrueCoat 360 Owner's Manual

Start Up

Start Up
Use only water-based or oil-based
(mineral spirit-type) materials with a
flash point greater than 100° F (38° C).
Do not use materials which state
"FLAMMABLE" on the packaging. For
more information about your material,
request SDS from distributor or retailer.
When spraying oil-based material, use
outdoors or in a well-ventilated indoor
area with a flow of fresh air.
Keep spray area well-ventilated. Keep
a good supply of fresh air moving through
the area.
NOTICE
Your sprayer is NOT compatible with harsh
cleaners such as chlorine bleach. Using
these cleaners will cause damage to the
sprayer.

Starting a New Job

If you are using the sprayer for the very first
time, see Flushing a New Sprayer, page 21.
Strain the Paint
8
Previously opened paint may contain dried
paint or other debris. To avoid priming
problems and tip clogs it is advisable to strain
the paint before using. Paint strainers are
available where paint is sold. Stretch a paint
strainer over a clean pail and pour the paint
through the strainer to capture any dried paint
and debris before spraying.
1. Install FlexLiner in the cup support.
2. Fill FlexLiner with material. Securely
tighten cup cover onto cup support.
Tighten so the arrow on the cup cover is
within range of the indicator on the cup
support.
ti24279a
ti26894a
ti23361a
333394L