Table of Contents
Advertisement
Chapter 2 Installation and Connection
Prepare this instrument and compatible equipment
(shown in the "System Chart" on page 30 in
"Appendix") before each use, and refer to the instruction
manuals of each system component. Install and connect
the equipment as follows:
In addition, this "INSTRUCTIONS (BASIC)" explains
the EVIS EXERA II Video System Center (CV-180).
For other equipment, refer to "Chapter 2 Installation and
Connection" in "INSTRUCTIONS (ADVANCED)."
WARNING
• Review this chapter thoroughly before each use. If the
equipment is not properly prepared before each use,
equipment damage, patient and operator injury and/or
fire can occur.
• When non medical electrical ancillary equipment is
used, connect its power cord via an isolation
transformer prior to connecting it to this instrument.
Failure to do so can cause electric shock, burns and/or
fire.
• Use this instrument, the remote control unit (MAJ-
898) and color printing pack (UPC-55) under the
conditions described in "Operating/Transport/Storage
Environment" on page 32 and
"Specifications" on page 32 in "Appendix".
Otherwise, improper performance, compromised
safety and/or equipment damage may result.
• Connect the power cord to a wall mains outlet, and the
connecting cables to each equipment firmly. If
connections are not made correctly/firmly, fire or
electric shock may result.
CAUTION
• Turn OFF all equipment before connecting them.
Otherwise, equipment damage or malfunction may
result.
• Use appropriate cables. Otherwise, equipment
damage or malfunction may result.
• The cables should not be sharply bent, pulled, twisted
or crushed.
• When you connect another piece of video equipment
between this instrument and the video system center,
be sure not to turn off the power of the video
equipment while this instrument is being used. If you
turn off the power of the video equipment, the video
signal may not be input to this instrument properly,
and this instrument may not work correctly, depending
on the video equipment connected.
2.1 Installation of the
Color Video Printer
(OEP-5)
CAUTION
• Do not place any object on the top of this instrument.
Otherwise, equipment damage may result.
• Keep the ventilation grilles of this instrument clear.
Blockage may cause overheating and equipment
damage.
• Place this instrument on a stable and level surface.
Otherwise, this instrument topple down or drop.
• If a trolley other than the mobile workstation (WM-
NP1, WM-WP1) is used, confirm that the trolley can
withstand the weight of the equipment installed on it.
• Do not use this instrument in an inclined position.
Unstable operation, damage and/or abnormal printing
may result.
• Do not install this instrument near a source of strong
magnetic radiation (microwave treatment device,
short wave treatment device, MRI, radio equipment,
etc.). Otherwise, this instrument may cause
malfunction.
2.1 Installation of the Color Video Printer (OEP-5)
2
9
Hide quick links:
Advertisement
Table of Contents
