Control From The Connected Equipment - Olympus OEP-5 Instructions Manual

4.2 Control from the
Connected
Equipment
This document, "INSTRUCTIONS (BASIC)," explains
the use of the EVIS EXERA II video system center (CV-
180) with this instrument.
Refer to "INSTRUCTIONS (ADVANCED)" when you
use equipment other than the equipment introduced in
"INSTRUCTIONS (BASIC)" or when you attempt to
control this instrument from the panel or the remote
control unit (MAJ-898) (optional).
CAUTION
• When this instrument is controlled from the EVIS
EXERA II video system center (CV-180), do not
perform the following tasks from this instrument or
remote control unit (MAJ-898) (optional).
– Setting up the print quantity
4
– Setting up the number of multi-pictures
– Changing memory page
– Clearing a captured image
– Moving the pointer
Because of the difference between settings of the
EVIS EXERA II video system center (CV-180) and
settings of this instrument, desired operation may not
be carried out, or image data may disappear.
• The number of multi-picture images cannot be set to
"8" or "16."
• Do not set the number of multi-picture images to "8"
or "16" from EVIS EXERA II video system center
(CV-180). If it is set as "8" or "16," it will be set as "1."
• Do not turn OFF or take out the paper tray while
printing is in progress. Otherwise, paper jam and/or
malfunction may result.
• Do not open the front door or take out the paper tray
while printing is in progress. Otherwise, paper jam
and/or malfunction may result.
• Do not leave 10 or more print sheets on the paper exit.
Otherwise, paper jam may result. Also, even when the
number of print sheets is less than 10, message
"REMOVE PRINTS" may be displayed on the
monitor and LCD panel and printing is interrupted
depending on the print sheet conditions. If this occurs,
remove the print sheets from the paper exit. Printing
will resume automatically.
• If you turn this instrument OFF while the PRINT lamp
is lit, the ink ribbon quantity displayed on the
remaining ink ribbon display on the LCD panel and/or
the monitor may not match the actual ink ribbon
quantity remaining.
Be sure to turn this instrument OFF after the printing
is completed and the PRINT lamp turns off.
26

4.2 Control from the Connected Equipment

NOTES
• Refer to the instruction manuals supplied with the
connected equipment.
• If print sheets jam during printing, take the
measures recommended in to "4.3 In the Case of
a Paper Jam" on page 27.
• An image cannot be stored in a memory page that
is currently printing, or is reserved for printing.
Wait until the printing completes.
• If you open the front door during printing,
printing is interrupted. If you close the front door,
the print sheet being printed is ejected. To print
again, press the "PRINT" button.
• If the remaining print sheets in the paper tray
decreases, a rattling sound may be heard during
printing. This is not a malfunction.
• Depending on the environment in which this
instrument is used, or the condition of the print
sheets, printed sheets output from the paper exit
may go over the stopper and drop from the paper
exit. Printed sheets may slide between previously
ejected print sheets, and may not stack up in
printed order.
1
Set up the connected equipment as shown in Table
3.1 in "3.3 Setup of Connected Equipment" on page
20.
2
Set up the color video printer (OEP-5) according to
the connected equipment as described in "3.5 Setup
of This Instrument" on page 22.
3
Control as described in the instruction manuals for
the connected equipment (see Table 4.1).
Table 4.1
connected The part indicated to the
equipment instructions manual
CV-180 "5.5 Printing images"