Inspection Of The Lcd Panel Display - Olympus OEP-5 Instructions Manual

3.4 Inspection of the
LCD Panel Display
The LCD panel displays the information and messages
according to the conditions of this instrument.
CAUTION
If an error or warning message is displayed, refer to
"Countermeasures Against Messages" in "7.1
Troubleshooting Guide" in "INSTRUCTIONS
(ADVANCED)", and take the appropriate measures.
1
Turn the color video printer (OEP-5) ON as
described in "3.1 Inspection of the Power Supply"
on page 14.
2
Confirm that the LCD panel displays the startup
message and that the display then changes as shown
in Figure 3.17.
For details of each item, refer to "INSTRUCTIONS
(ADVANCED)."
Startup message
Caption display
This field shows "C" when the printed picture is
set to contain a comment (caption).
Input signal display
This field shows the
selected input signal
format (see Table 3.2).
Print quantity display
This field shows the
number of prints.
Memory page display
This field shows the
selected memory page.
Print layout (ZOOM MODE
Settings) display
This field shows the setting of
the print layout (see Table 3.3).
Operation mode display
This field shows the operation mode of this
instrument.The number on the left is the number of
images used in multi-picture printing. Also, in the case of
a printed image with white frame, "F" is displayed on the
right side of the number of images. The number on the
right indicates the current position of the pointer. It is the
location where the image is stored next.
Figure 3.17
Remaining ink ribbon
display
This field shows the
remaining ink ribbon.
Source/Memory display
This field shows "S"
when the source image
is displayed on the
monitor, and shows "M"
when the memory image
is displayed on the
monitor.
Table 3.2
Display Input signal format
VIDEO VBS composite video
SVIDEO Y/C signals
SD RGB signals (SDTV)
HD RGB signals (HDTV)
SDAUTO Auto input detection (for SDTV input)
HDAUTO Auto input detection (for HDTV input)
SD-SDI SDI signal (SDTV)
HD-SDI SDI signal (HDTV)
SSDAUT Auto SDI signal input detection (for SDTV
input)
HSDAUT Auto SDI signal input detection (for HDTV
input)
Table 3.3
Display ZOOM MODE Settings
OFF OFF (Print normally.)
PT PART (Only the "4:3" and "5:4" aspect
ratios are available.)
ALL ALL (Only the "4:3" and "5:4" aspect
ratios are available.)
RM REMOTE (All aspect ratios are available.
ZOOM MODE activates depending on the
signal being input.)
This setting is for future expansion. Not
used.

3.4 Inspection of the LCD Panel Display

3
21