Restart Printing - Olympus OEP-5 Instructions Manual

3
Remove the single screw by which the back cover
plate is secured, using a coin, etc. (see Figure 4.5).
4
Pull the back cover plate up and remove it from the
main body (see Figure 4.6).
4
5
Remove the jammed paper slowly (see Figure 4.7).
6
Replace the back cover plate (see Figure 4.8).
28
4.3 In the Case of a Paper Jam
Figure 4.5
Figure 4.6
Figure 4.7
Figure 4.8
7
Secure the back cover plate by the screw removed,
using a coin, etc. (see Figure 4.9).
Confirm that the screw holes of rear of the
main body and the back cover plate align
before securing.
Figure 4.9
8
Reset the paper tray and ink ribbon holder into the
color video printer (OEP-5).
Reconnect the power cord and other connecting
cables as they were.
Confirm that any connecting cables and the power
cord are securely connected.
NOTE
If jammed paper cannot be removed, or an error message
is displayed even after taking the above procedure, stop
using this instrument and contact Olympus.

Restart Printing

Even if a paper jam occurs during printing, the image of
the print is held in the flash memory of this instrument
so it can be reprinted.
CAUTION
• The image of a print stored in the flash memory is
overwritten each time a paper jam occurs. If image
data is overwritten, you will not be able to print the
image data stored before the paper jam occurred.
• Use the buttons on the front panel of this instrument
when restarting printing. Restart cannot be executed
by the keyboard of the connected equipment or remote
control unit (MAJ-898).
1
Press the power switch to turn ON.
2
When the message "RESTORE IMAGES? YES/
NO" is displayed on the monitor and the LCD
panel, press the "b" or "B" button to select "YES"
and press the ENTER button.