Olympus OEP-5 Instructions Manual page 16

4
Set a new ink ribbon on the ink ribbon holder.
Hold the ink ribbon right and remove the gear cover
(see Figure 3.5).
Gear cover
CAUTION
3
• Do not place an ink ribbon in a location exposed
to direct strong electromagnetic radiation.
Electromagnetic radiation may damage the IC
chip built into the ink ribbon, and the remaining
ink level cannot be correctly displayed.
• Do not touch the surface of the ink ribbon for
longer than is necessary. Do not leave it in a dusty
environment. If smudges or dust attach to the ink
ribbon, printing will not only be incorrect but also
damage to this instrument may occur.
16
3.2 Installation of the Color Printing Pack (UPC-55)
Figure 3.5
5
Firstly, firmly secure the white gear in the ink
ribbon, and then the gray gear (see Figure 3.6).
m
Figure 3.6
CAUTION
Install the ink ribbon securely on the ink ribbon
holder, and be sure that the ink ribbon film is
stretched tightly (not loose), otherwise printing will
not only be incorrect but may result in damage to
this instrument.
NOTE
Also refer to the caution label on the ink ribbon
holder.
6
Turn the gears in the arrow direction until the
magenta section of the ink ribbon appears all over
to remove slack from the ink ribbon (see Figure
3.7).
Gear (White)
Caution label
Gear (Gray)
Caution label