Use; Requirements For The Set-Up Location; Connecting To A Power Supply - Silvercrest SFPW 360 B1 User Manual

Use

Requirements for the set-up location

►
►
►
♦ Place the device on a flat and level surface .

Connecting to a power supply

This device can be operated with batteries or the
power adapter . For a permanent projection, permanent
display illumination and to use the USB port
the power adapter u must be connected .
Mains power operation:
♦ Ensure that the On/Off switch for permanent projec-
tion 0 is in the "OFF" position .
♦ Plug the low voltage plug on the power adapter u
into the connector socket e on the device and con-
nect the power adapter u to an easily accessible
power plug .
Battery operation:
♦ Open the battery compartment r on the rear of
the device by removing the battery compartment
cover t .
♦ Insert three AAA batteries into the battery compart-
ment r as indicated .
♦ Close the battery compartment r again .
■ 10
_330014_SFPW360B1_LB9.indb 10
When choosing a location for the device, ensure
that the device is not subjected to direct sunlight,
vibration, dust, heat, cold and moisture .
Do not set up the device in the vicinity of heat
sources, such as radiators .
Protect sensitive surfaces before setting up the
product .
│
US - EN
w,
SFPW 360 B1
03.09.19 12:2