Inserting The Camera - Ikelite 6961.09 Manual

3. Repeat with remaining lid snap(s).
4. Remove the housing back.

Inserting the Camera

1. Remove any lanyard or neck strap which may be attached to the
camera.
2. Check to see whether the camera's lens will fit through the port
opening of the housing. If not, the lens will need to be removed
from the camera body and reattached AFTER the camera body is
installed in the housing.
3. Remove the Camera Mounting Plate from the housing.
4. Pull the LCD screen away from the camera slightly to allow the
Camera Mounting Plate to attach properly to the bottom of the
camera.
5. Line up the Mounting Screw with the Camera Tripod Socket. Use
a coin or flat head screwdriver (preferred) to tighten the mounting
plate to the camera. Mounting Plate should tighten flush against the
bottom of the camera.
1/4-20 Mounting Screw
1/4-20 Threaded Hole
Camera LCD Screen
Camera Mounting Plate
Camera Tripod Socket
9