Grizzly G0812 Owner's Manual page 48

5. Remove fill cap (see Figure 72), then remove
drain plug and allow tank to empty into drain
pan.
Drain Plug
Figure 72. Drain plug and fill cap location.
6.
Clean fill cap with mineral spirits and allow to
air dry.
7. Clean tank screen (see Figure 73) with min-
eral spirits and blow dry with compressed air.
8. Inspect screen (see Figure 73) and tank fill
cap for any holes, and replace if any damage
exists.
9.
Open tank by removing hex bolts that secure
lid (see Figure 73).
Tank
Lid
Figure 73. Hydraulic fluid tank lid removed to
access for cleaning.
-46-
10. Wipe out as much residual fluid and con-
Fill Cap
11. Re-install tank lid and screen.
12. Replace drain plug, then fill tank approxi-
13. Re-install tank fill cap and front access panel.
Tank Screen
taminants from tank as possible. We highly
recommend that tank be cleaned out with
pressure washer or steam cleaner and fully
dried with compressed air for best results.
mately 80 percent full with 3.17 quarts of ISO
32 or equivalent hydraulic fluid.
Model G0812 (Mfd. Since 2/16)