Section 3: Setup; Unpacking; Needed For Setup; Inventory - Grizzly G0812 Owner's Manual

Unpacking

This machine was carefully packaged for safe
transport. When unpacking, separate all enclosed
items from packaging materials and inspect them
for shipping damage. If items are damaged,
please call us immediately at (570) 546-9663.
IMPORTANT: Save all packaging materials until
you are completely satisfied with the machine and
have resolved any issues between Grizzly or the
shipping agent. You MUST have the original pack-
aging to file a freight claim. It is also extremely
helpful if you need to return your machine later.
SUFFOCATION HAZARD!
Keep children and pets away
from plastic bags or packing
materials shipped with this
machine.

Needed for Setup

The following items are needed, but not included,
for the setup/assembly of this machine.
Description
• Safety Glasses (for each person) ............... 1
• Cleaner/Degreaser (refer to Page 15) ........ 1
• Disposable Shop Rags ............................... 1
• Lifting Equipment
(Rated for at least 1700 lbs.) ...................... 1
• Precision Level ........................................... 1
• Open-End Wrench 10, 12, 24mm ..........1 Ea
• Hex Wrench 4, 5, 6mm .........................1 Ea
• Additional Person ....................................... 1
• Hammer ...................................................... 1
• Pry Bar ....................................................... 1
-14-

SECTION 3: SETUP

Qty

Inventory

The following is a list of items shipped with your
machine. Before beginning setup, lay these items
out and inventory them.
If any non-proprietary parts are missing (e.g. a
nut or a washer), we will gladly replace them; or
for the sake of expediency, replacements can be
obtained at your local hardware store.
Box Inventory (Figure 7)
A. Work Stop Arm ........................................... 1
B. Work Stop ................................................... 1
C. Work Stop Rod ........................................... 1
D. Splash Guard ............................................. 1
E. Hex Bolts M16-2 x 75 ................................. 4
F.
Hex Nuts M16-2 .......................................... 4
A
C
B
E
F
Figure 7. Box inventory.
NOTICE
If you cannot find an item on this list, care-
fully check around/inside the machine and
packaging materials. Often, these items get
lost in packaging materials while unpack-
ing or they are pre-installed at the factory.
Model G0812 (Mfd. Since 2/16)
Qty
D