Advertisement
CONNECTIONS TO BE MADE
• For all other radios: Connect the 3.5mm jack from the AXSWC harness, into the jack on the
aftermarket radio designated for an external steering wheel control interface. Please refer to
the aftermarket radios manual if in doubt as to where the 3.5mm jack goes to.
• Connect the Yellow male RCA jack labeled "To Reverse Camera Input (Radio)", to the backup
camera input.
Note: The aftermarket radios backup camera input will be used to display the vehicle
settings. If the radio doesn't have a backup camera Input, then there will be no visualization
of the vehicle settings. An externally mounted screen could be substituted in this situation.
• If installing an aftermarket backup camera, connect the Yellow female RCA jack labeled "To
Reverse Camera", to the camera.
INSTALLING THE AXDIS-VW1 INTERFACE
(CONT.)
With the key in the off position:
• Connect the AXDIS-VW1 harness to the AXDIS-VW1 interface, and then to the wiring harness
in the vehicle.
• Connect the AXSWC harness to the AXSWC interface, and then to the AXDIS-VW1 interface.
3
REV. 2/4/2020 INSTAXDIS-VW1
Advertisement
