Advertisement
Quick Links
GM Data Interface
• Provides accessory power (12-volt 10-amp)
• Retains R.A.P. (retained accessory power)
• Provides NAV outputs (parking brake, reverse,
and speed sense)
• Retains chimes through an onboard speaker
• AXDI-GMLN11 interface • AXDI-GMLN11 harness
CHEVROLET
Cobalt
HHR
Malibu
PONTIAC
G5
G6
Axxess Integrate
Installation instructions for part AXDI-GMLN11
AXDI-GMLN11
2006-2012
INTERFACE FEATURES
• Pre-wired AXSWC harness (AXSWC sold
separately)
• Designed for non-amplified models, amplified
models, or when bypassing a factory amplifier
• Retains balance and fade
• Micro "B" USB updatable
INTERFACE COMPONENTS
APPLICATIONS
PONTIAC (CONT)
2007-2010
G6 (5th digit of VIN must
2006-2011
be a J, K, or L)
2008-2012
Solstice
SATURN
2007-2009
Aura
2010
Sky
axxessinterfaces.com
Connections to be made ................................................... 2
Installing the AXDI-GMLN11 ............................................. 3
Initializing the AXDI-GMLN11 ........................................... 3
TOOLS REQUIRED
• Wire cutter • Crimp tool • Solder gun • Tape
• Connectors (example: butt-connectors, bell caps, etc.)
2009
2006-2009
2007-2009
2007-2009
•
metraonline.com
Table of Contents
CAUTION!
All accessories, switches, climate controls panels, and
especially air bag indicator lights must be connected before cycling
the ignition. Also, do not remove the factory radio with the key in the
on position, or while the vehicle is running.
© COPYRIGHT 2020 METRA ELECTRONICS CORPORATION
Advertisement
Related Manuals for Axxess AXDI-GMLN11
Summary of Contents for Axxess AXDI-GMLN11
- Page 1 • Wire cutter • Crimp tool • Solder gun • Tape • Retains balance and fade • Retains chimes through an onboard speaker • Connectors (example: butt-connectors, bell caps, etc.) • Micro “B” USB updatable INTERFACE COMPONENTS • AXDI-GMLN11 interface • AXDI-GMLN11 harness APPLICATIONS CHEVROLET PONTIAC (CONT) Cobalt 2007-2010...
- Page 2 AXDI-GMLN11 Connections to be made From the AXDI-GMLN11 harness to the aftermarket radio: 12-pin pre-wired AXSWC harness: • Connect the Black wire to the ground wire. • This harness is to be used along with the optional AXSWC (not included) to retain steering wheel audio controls.
- Page 3 Attention! If the interface loses power for any reason, the following steps will need to be performed again. Also, if installing an AXSWC connect it after you initialize and • Connect the AXDI-GMLN11 harness into the interface, and then to the wiring test the interface/radio, with the key in the off position.
- Page 4 Installation instructions for part AXDI-GMLN11 IMPORTANT If you are having difficulties with the installation of this product, please call our Tech Support line at 1-800-253-TECH. Before doing so, look over the instructions a second time, and make sure the installation was performed exactly as the instructions are stated.