Table of Contents
Advertisement
Quick Links
Only use this heater as described in this manual. Any other use is not
recommended by the manufacturer, and may cause fire, electric shock, or
other personal injury.
WARNING! Read and understand this entire owner's manual, including all
safety information, before plugging in or using this product. Failure to do
so could result in fire, electric shock, serious personal injury, or death.
WARNING! INDOOR use only! NEVER use this heater outdoors!
SAVE THESE INSTRUCTIONS!
CAUTION! Keep this owner's manual for future reference. If you sell or give
this product away, make sure this manual accompanies this product.
IMPORTANT SAFETY INFORMATION!
ELECTRIC FIREPLACE STOVE
MODEL FS2210C
OWNERS MANUAL
NO VENTING REQUIRED
Power: 110 ~ 120V AC; 60 Hz
Maximum Heat: 1500 WATTS
Advertisement
Table of Contents
Related Manuals for e-Flame USA FS2210C
Summary of Contents for e-Flame USA FS2210C
- Page 1 ELECTRIC FIREPLACE STOVE MODEL FS2210C OWNERS MANUAL Only use this heater as described in this manual. Any other use is not recommended by the manufacturer, and may cause fire, electric shock, or other personal injury. WARNING! Read and understand this entire owner’s manual, including all safety information, before plugging in or using this product.
- Page 2 WARNING l ALWAYS keep electric cords, home furnishings, drapes, clothing, papers, or other combustibles at least 3 feet (0.9m) away from the front of this heater, and away from the bottom, sides, and rear of this heater. l DO NOT place the heater near a bed because objects such as pillows or blankets can fall off the bed and be ignited by the heater.
- Page 3 l Risk of electric shock! DO NOT OPEN! No user-serviceable parts inside! l ALWAYS disconnect this unit from the power supply before performing any assembly or cleaning, or before relocating the electric fireplace. l ALWAYS store this heater in a dry location. NEVER use the fireplace if it has become wet.
-
Page 4: Tools Needed For Assembly
l Remove all parts and hardware from the carton and place them on a clean, soft, and dry surface. Make sure all parts are dry, and the power cord and plug are not damaged. See IMPORTANT SAFETY INFORMATION on pages 2 and 3. l Compare the contents with the parts list to make sure nothing is missing. - Page 5 ASSEMBLY ALWAYS make sure the unit is unplugged before beginning assembly! NEVER move or clean the heater, or change the bulbs, while it is plugged in. 1) Carefully turn the STOVE (A) upside down and lay it on a clean soft surface. 2) Insert the TAB of one LEG (B) into the SLOT in the corner of the stove frame.
-
Page 6: Operation
OPERATION When the heat function is used for the first time, a slight odor may be NOTICE present. This is normal and should not occur again unless the heater is not used for an extended period of time. -
Page 7: Care And Maintenance
CARE AND MAINTENANCE TEMPERATURE LIMITING CONTROL This heater is equipped with a Temperature Limiting Control. Should the heater reach an unsafe temperature (212°F / 100°C), the heater will automatically turn OFF. To reset: 1. Unplug the power cord from the outlet. 2. -
Page 8: Limited Warranty
Light bulbs become very hot during use. Allow at least 10 minutes for the bulbs to cool before touching. To inspect or replace the bulbs, first unplug the power cord from the outlet. Locate the access panel on the back of the stove. Remove the screws and the panel. Check the bulbs to be sure they are finger tight and in working order.