Basic Menu Operation - JVC D-ILA DLA-M2000LU Instructions Manual

Menu Operations

Basic Menu Operation

When the MENU button is pressed, the projector enters Video or PC menu mode by responding to the input signal being
received.
Video menu mode:
Enters this mode when video-device-related signals are
input from the following devices.
• Video devices connected to the VIDEO IN (Y/C and
VIDEO) terminals.
• A video device connected to the PC 2 terminals, which
outputs component signals (Y, B-Y, R-Y) or DTV-format
signals (Y, P , P ).
B R
PC menu mode:
Enters this mode when computer-related signals are input
from the following devices.
• A computer connected to the PC 1 terminal.
• A computer connected to the PC 2 terminal, which outputs
analog RGB, V, H/Cs signals.
1
Press the MENU button.
The main menu is displayed on the screen.
Remote control unit
MENU
2 Press the cursor button 5 or ∞ ∞ ∞ ∞ to
select an item in the main menu.
Remote control unit
3 Press the cursor button 3 3 3 3 or the
ENTER button to enter the submenu.
The submenu corresponding to the item selected in step
2 is displayed on the screen.
* When you selected "Information" in step 2, no
submenu is available.
Remote control unit
42
4
5
Projector
MENU
When an item which has the "ENTER" message has been
selected in step 4, press the ENTER button to move to the
next submenu.
• All reset
• Position
• Decoder
Projector
• Keystone
• Options 1 → (Refer to page 52)
• Options 2 → (Refer to page 52)
To exit the main menu:
• While the main menu is displayed, press the MENU button.
The main menu disappears and the original picture image
resumes.
To exit the submenu:
• While the submenu is displayed, press the ESCAPE
button.
The menu returns to the previous menu.
• To exit the menu mode directly, press the MENU button.
The submenu disappears and the original video image is
restored.
Projector
Press the cursor button 5 or ∞ ∞ ∞ ∞ to
select an item in the submenu.
When a "Language" has been selected in step 2, press
to set the language.
Remote control unit
Press the cursor button 2 2 2 2 or 3 3 3 3 to set
or adjust the value.
Remote control unit
→ (Refer to page 47)
→ (Refer to page 49)
→ (Refer to page 44)
→ (Refer to page 52)
Projector
Projector