JVC D-ILA DLA-M2000LU Instructions Manual page 14

q
PRESET button
This PRESET button only works as a reset button for the
direct button adjustment of the VOLUME button and
KEYSTONE button of the control panel and the VOLUME
button and DIGITAL ZOOM button of the remote control.
When adjusting the volume, keystone or digital zoom
(when the setting is displayed on the screen) the
adjusted value is reset to that which was set when the
projector was shipped from the factory. Of the menu
items, this button only works for the keystone setting
screen.
w
FREEZE button
During projection of an image on the screen, press this
button to obtain a still picture.
To restore normal projection, press it again. (Refer to
page 36.)
* Depending on the video signal source (UXGA, etc.), this
button does not work.
e
HIDE button
Use this button to turn off the image on the screen and
audio sound temporarily. Pressing it again makes the
image and audio sound to resume. (Refer to page 34.)
r
FOCUS +/– buttons
Use these buttons to adjust the focus of the projected
video image.
+: The focus point becomes more distant.
–: The focus point becomes nearer.
t
VOLUME +/– buttons
Use these buttons to adjust the sound volume:
+ : Increase the volume level. (0 → 50)
– : Decrease the volume level. (50 → 0)
(Refer to page 33.)
y
QUICK ALIGN. (Quick Alignment) button
Use this button to automatically align "Horizontal and
vertical position", "Tracking" and "Phase" for the
projected image.
During the automatic alignment, "Quick Alignment"
appears on the screen, and disappears after alignment is
finished. (Refer to page 35.)
* The "Quick Alignment" function only works when the
signal is input from the input terminal of either PC 1 or PC
2. It does not work when the signal is input from the
VIDEO IN terminal (VIDEO or Y/C input terminal).
CAUTION
• Automatic alignment with the quick alignment function
should be carried out on a bright still-picture. This function
may not work correctly on a dark picture or motion-picture.
If adjustment with this function is not satisfactory, adjust
"Horizontal and vertical position", "Tracking" and "Phase" in
the menu mode.
u
ZOOM T/W buttons
Use these buttons to adjust the projected screen size.
(They work only if the lens unit with a zooming function is
used.)
T (Tele): The projected screen size decreases.
W (Wide): The projected screen size increases.
Controls and Features
13